Replacement Pipe Mount for Bulldog Jack
Updated 02/03/2026 | Published 07/22/2024
Question:
I need the weld on brackets for my 10 ton Bulldog jack. I need both flat pieces to weld on my jack as well as my implement. And I need the cylinder pieces as well to weld to the plates and the pin thru.
asked by: Beth C
Expert Reply:
Hi Beth; I'm assuming you want the same replacement pipe mount you ordered a few years ago. That one was discontinued and replaced with the Bulldog Replacement Pipe Mount for Swivel Jacks - 2-1/4" Male - Weld On - 5/8" Pull Pin # BD500240 which has the same dimensions. This will work with the Bulldog Replacement Pipe Mount for Swivel Jacks - 2-1/2" Female - Weld On - 5/8" Pull Pin # BD005024. We only have the actual pipe mounts so the plates are something you will have to source elsewhere or have fabricated.
Robin H.
2/3/2026
Hi Beth, how did the new Bulldog pipe mounts work out for your 10-ton jack setup? Your update could make it easier for the next person trying to match those weld-on brackets.