5-Way Flat to 4-Way Flat Adapter To Connect To Trailer and Dexter Surge Brake On EZ Loader Trailer
Published 04/19/2024
Question:
Good day, I am looking for a EZ loader wiring harness. It is a 5 way that connect to a 4 way but has an extra white wire that goes to my Dexter surge brake unit. The trailer VIN is 1ZETANSS0LA001974. Thanks Jim
asked by: James D
Expert Reply:
It sounds like you are needing the opposite of the Tow Ready 4 Pole to 5 Pole Trailer Wiring Adapter # 20036. As we do not have the same type of adapter with the opposite male and female ends you could build one using the 5-Flat # HM47910 and 4-Flat # HM48035 ends. Then you will be able to run the additional wire to the Dexter surge brake for your reverse lockout.
I hope this helps you Jim, since we do not carry the EZ loader specific adapter.
Continue Researching
- Q&A: Can a 4-Way Trailer Connector be Plugged Into a 5-Way Vehicle End Trailer Connector
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Q&A: Wiring New 4-Way Connector on Trailer with 5 Wires
- Article: Trailer Wiring Diagrams
- Q&A: New Brake Assemblies, Hub/Drums, Brake Lines, and Bearing Buddy for Trailer with 3,500 lb Axle
- Q&A: Recommended Disc Brake Conversion Kit for 5200-lbs Lippert Axles with 6 on 5-1/2 Bolt Pattern
- Q&A: How to Identify Correct Replacement Bearings and Seals for Boat Trailer
- Q&A: Where To Attach Blue Wire From 5 Wires on Trailer When Installing a 7-Way Connector
- Q&A: Can a 5-Way Adapter Work with a Trailer 4-Way Connector
- Article: How to Bleed Your Trailer Surge Brakes
- Article: How to Measure for Trailer Hitch Drop
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)