Will Bargman Triple Trailer light Work On 1978 Great Divide Trailer
Updated 04/02/2014 | Published 04/01/2014
Products Featured in This Question
Question:
1978 Great Divide I am looking to replace the lights on my Trailer and was wondering if these lights would be a proper repllacement
asked by: Charley
Expert Reply:
The Bargman Triple Trailer Light part # 47-84-005 you referenced measures14-1/16" long x 6-15/16" wide, and requires an opening of 12-11/16" x 5-1/2" in the outer wall of the trailer to install. Although there are 8 mounting holes on the light the recessed mount design will determine if this will work for your trailer. After doing some research I was unable to find the light assemblies you have on your 1978 Great Divide travel trailer.
Since these are LED lights you are looking at, the only issue you would need to be concerned with would be if your towing vehicle has a bulb-out sensor installed. If so, the vehicle turn signals may hyperflash because the LED lights draw so little power. The sensor would think that a bulb is burned out. If this is the case then you would need to install resistors like part # DI34ZR. You would install a sensor on the left turn circuit a sensor on the right turn circuit of the trailer to prevent the hyperflash.
I have attached a link to our product pages for lighting. Before buying a light assembly I recommend you remove one of the lights and take measurements of the mounting locations. You can then choose the lights that would work for your trailer.
