Can a Lomax Tonneau Cover Be used With a Thule Ladder Rack for a 2023 Toyota Tundra

Question

Question:

Can this cover be used with a Thule rack system to carry a canoe or kayaks. I am looking the Lomax folding tonneau cover and am concerned about compatibility. The vehicle is a 2023 Toyota Tundra short bed .

asked by: Robert H

0

Expert Reply:

No, the Lomax Hard Tonneau Cover # LOM47JR can be only used with a Adarac ladder rack like the Adarac Pro Series Custom Truck Bed Ladder Rack # A92BG.

You'd have to use the BAK Revolver X2 Hard Tonneau Cover # BAK39409 instead as this cover would be narrow enough to be able to be rolled up without hitting anything.

expert reply by: Bryce D

0

Answer 1

I took a look at the installation for your Ultra-Flex Tri-Fold on your 2017 Chevrolet Silverado 3500 and it looks like it completely covers the sides of your bed rails where the TruXedo Truck Luggage Expedition Truck Bed Cargo Management System…

view full answer...

Answer 2

To determine if the DeeZee Specialty Series Wheel Well Toolbox, #DZ95D, will fit your 2013 Toyota Tundra, you will need to go by the measurements of the box. I have included a picture showing the dimensions for you. It is 8-1/2 inches wide, 20-1/2…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 5

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 6

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 7

Hey Melanie. The reason you can't find a replacement for your GE ARC15AACBL2 15,000 btu air conditioner is because they phased them out. In 2025 all RV AC systems had to change over to a new coolant called R32. This was a EPA mandated decision.…

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 9

Hey Tim welcome back! Your ARH15AACBL2 GE AC unit has the old 410a refrigerant in it so the GE Appliances item #GE64FR you were looking at isn't going to work as a replacement. The EPA mandated R32 refrigerant has been used in all new AC's…

view full answer...

Answer 10

The best replacement option we offer for a Atwood GC10A-4E Water Heater is tankless, the Furrion RV Tankless Water Heater part #FR68SR. It won't be a direct replacement but still pretty easy nonetheless as they are very similar. That said, you…

view full answer...

Can a Lomax Tonneau Cover Be used With a Thule Ladder Rack for a 2023 Toyota Tundra

Products Featured in This Question

Continue Researching