Availability of a 4-Way Flat Adapter To Prevent Bulb Fault Error on 2023 Ford Escape
Updated 09/18/2023 | Published 09/16/2023
Question:
I have a 2023 ford escape, with a 4 pin towing connector. I just got a bully hitch step with led brake light and it’s tripping the “check bulb fault” because the leds don’t pull enough to report. I saw a solution elsewhere on the site for an adapter that has diodes that increase amp draw, but that adapter was for a 7 pin. Do you have a similar adapter that would solve my issue? Thanks
asked by: Joe H
Expert Reply:
While we do not have an adapter pre made you can easily create your own by wiring in 3 Load Resistors # P230004A on a 4-Way Extension # HM48145. The resistors will create a larger power draw and confuse your 2023 Ford Escape into thinking they are higher draw lights. Then you will be able to use the Bully Hitch Step without the check bulb fault.
Product Page this Question was Asked From
Putco LED Light Bulb Load-Resistor Kit - Aluminum
- Accessories and Parts
- Trailer Lights
- Load-Resistor Kit
- Aluminum
- Putco
more information >
Continue Researching
- Q&A: How to Flat Tow 2019 Ram 1500 Limited 4x4 Behind Motorhome
- Q&A: Correct TorkLift Tie-Downs for 2021 Ford F-350 XL Long Bed With Regular Cab
- Q&A: Trailer Hitch Recommendation for 2006 Subaru Forester
- Q&A: How to Keep LED Turn Signal Lights on Toolbox From Flashing with Brake Pedal Pressed
- Q&A: Load Resistors to Fix Rapid Flashing LED Lights
- Q&A: How To Wire The Reed Switch Of The Demco Air Force One With Coachlink Monitor
- Q&A: What Could Be Causing the Demco Air Force One to Leak
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Trailer Wiring Diagrams
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Testing Breakaway Systems
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers