How Does Solar Panel Controller Connect to Battery Bank that's in Parallel
Published 08/03/2023 >
Question:
I bought a solar panel and controller from you. I have 3 each 12v 100ah batteries wired in parallel. Where do I put the wires from the solar controller on the batteries? I mean do they both go on the first or last battery? Do I put the positive charging wire on the positive terminal on the last battery and the negative on the first? Any help would be greatly appreciated.
asked by: Bill S
Expert Reply:
Basically you would want to wire the solar panel controller the same way as the battery bank is wired (in parallel). So on the main power and ground wires that run to the rest of the RV for power. This will make sure the bank is charged evenly.
Product Page this Question was Asked From
Go Power PWM Solar Charge Controller with USB Port - LCD Digital Display - 10 Amp - 12V
- Solar Charge Controllers
- PWM
- 10 Amp
- Digital Display
- Gel
- AGM
- Flooded
- Lithium (liFePO4)
- Go Power
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Replacement for Older Go Power PWM-30 Solar Controller
- Q&A: Will the Go Power PWM Solar Charge Controller w/ Bluetooth Work w/ Lithium Batteries?
- Q&A: Go Power PWM Solar Charge Controller # 34280503 Dimensions
- Q&A: Complete Flat Towing Setup for a 2025 Ford Ranger XLT 4X4
- Q&A: Can MORryde StepAbove RV Steps with Strut Assist Use Removable Mounting Plate
- Q&A: Street Tire Recommendation to Replace ST235/75R15 that is Quieter
- Q&A: How Long are the Screws in the Replacement Mounting Hardware for Go Power Rigid Solar Panels Kit?
- Article: RV Sway Control, Stabilization, and Suspension Enhancement
- Article: How to Charge a Trailer Battery While Driving: 3 Common Problems (And How to Fix Them)
- Article: Best RV Roof Vents
- Article: How to Replace or Install an RV Roof Vent
- Article: Stability Control for Heavy Duty Vehicles
- Article: Solar Setups for Beginners (Feat. REDARC)
- Article: 4-Step Guide to Installing RV Solar Power

