Replacement 4-Way Flat Wiring Connector For a 2010 Palomino Pony Popup Camper
Published 03/24/2023
Products Featured in This Question
Question:
Hi! I have a 2010 Palomino Pony pop up camper. The right side lights wont work despite new bulbs, so the connector from it to the towing wiring on the car is probably not functioning as intended. Wiggling it around triggers some of the lights but it doesnt last. Do you have the 4 pin wiring/connector for this type of camper? The car wiring is good as I just installed it from you guys.
asked by: Cin
0
Product Page this Question was Asked From
Hopkins Endurance Easy-Pull Harness with 4-Pole Flat Connector - LED Tester - Trailer End - 12"
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- 4 Flat
- Plug and Lead
- Hopkins
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Trailer Taillight Lens with SAE STIAP2 04 DOT DOT Number On It
- Article: Trailer Lighting Requirements
- Q&A: Choosing Between a Standard Trailer Fender or One with a Backing Plate
- Q&A: Fenders for 1996 EZ-Loader Boat Trailer
- Q&A: Recommended Trailer Fender for 14 Inch Wheels and 28 Inches Long
- Article: How to Clean Weld Nuts for the Installation of a Trailer Hitch | etrailer.com
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Recommendation for Higher Gauge Wiring to Use on Trailer
- Q&A: Outer Diameter of Deka Jacketed 4 Conductor Cable # DW04923-1
- Q&A: Dimensions of Channel Tongue Trailer Couplers for 2 Inch Frame
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)