Recommended Hitch and Wiring Harness for a 2006 Buick Lucerne

Updated 03/15/2023 | Published 03/14/2023

Products Featured in This Question

Draw-Tite Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4"

(41)

$253.98

1-7/8" Hitch Ball - 3/4" Diameter x 1-9/16" Long Shank - Chrome - 2,000 lbs

(2621)

$16.53

2" Hitch Ball - 3/4" Diameter x 1-9/16" Long Shank - Chrome - 3,500 lbs

(2621)

$18.47

Draw-Tite Drawbar for 1-1/4" Hitch - 2-1/8" Rise, 2-3/4" Drop - 6-5/8" Long - 2K

(2329)

$35.48

Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector

(31)

$31.10

Question:

2006 Buick Lucerne CXS Can you come up with a design for the vehicle I put above? Show me the design before I make a decision.

asked by: Elvin A

Expert Reply:

I am not sure what you mean by design but I have listed the parts below that you would need to set your 2006 Lucerne up to tow a trailer or use an accessory like a bike rack or cargo carrier. I have also linked an installation video and picture to show you what this hitch looks like installed. If you're not looking for a hitch and wiring harness then go ahead and email me back with a more specific description of what you mean by design.

Draw-Tite Trailer Hitch Receiver item # 36309. This is a class II hitch with a 1-1/4" receiver that has a 3,500 lbs towing capacity and a 350 lbs maximum tongue weight. It bolts to your Buick with included hardware.

Curt T-Connector Vehicle Wiring Harness item # 56047. This custom-fit T-connector plugs into your Buick's wiring harness, which is located behind interior trim panels in your rear cargo area.

For a ball mount you'd need the Draw-Tite Drawbar item # 3593 and then for hitch balls item # 19258 for a 2 inch ball or item # 19256 for a 1-7/8 inch ball.