Switching Between 1.5" and 1" Leveling Blocks on Hopkins Electronic LED Smart Level
Published 02/16/2023
Question:
How do you set the Hopkins RV Smart-Level 08201 to show 1inch increments?
asked by: Roger G
0
Expert Reply:
The factory setting for the Hopkins Electronic LED Smart Level # HM08201 is 1.5". To switch it to 1" mode you will start by pressing the on/off button until the yellow lights flash. Then, immediately press the button again to switch to 1" mode. The red LED will light to indicate the leveler is set to 1". This information can be found on the inside of the cover. I have also attached an image below for your reference.
expert reply by:
Robin H
0
Hopkins Smart Level Instructions.
(click to enlarge)
(click to enlarge)
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: How Much Does a Slide Topper Typically Hang Over a Slide Out
- Q&A: How to Determine Correct Slide Out Awning for Trailer
- Q&A: Replacement Bearing Kit for a 5,200 lb Dexter Axle
- Q&A: How to Power Electric Trailer Jack When Vehicle With 7-Way Isnt Available
- Q&A: Recommended Trailer Level That Does Not Require Drilling
- Q&A: Replacement Air Line Kit For Reese Goose Box 20000lbs
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Q&A: Will the Prodigy RF Brake Controller Prevent a Trailer Mounted Battery from Charging
- Article: How to Measure for Trailer Hitch Drop
- Article: Converting Your RV Water Heater to Tankless
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices