How to Ground Optronics Rectangular Tractor and Utility Lamp # TL46FS to Horse Trailer
Updated 01/14/2014 | Published 01/12/2014
Question:
I purchased 3 of these lights for my horse trailer. My question is if I can ground them inside the housing of the light itself, or what is the best method to ground this when I only have a hot write coming out of the trailer? Thank you
asked by: Ben
0
Expert Reply:
For best performance, you would want the ground wire to attach directly to the trailer frame. It would also be acceptable to ground the wire to a piece of metal that is directly connected to the trailer frame. I would not recommend grounding to the interior of the lamp housing.
expert reply by:
Mike L
0
Product Page this Question was Asked From
Optronics Utility Work Light - Incandescent - Flood Beam - Rectangle - Clear Lens
- Work Lights
- Flood Lights
- Work Lights
- Exterior Lights
- Rectangle
- Pedestal Mount
- Flood Beam
- Incandescent Light
- White
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: What is Difference Between Pollak Metal 7-way and Roadmaster
- Q&A: Replacement Converter Charger for a Inteli Power 9100 Model PD9155
- Q&A: Compatibility of Dexter Drum Hub on Lippert Axle of 2017 Jayco North Point 5th Wheel
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Looking For Replacement For ProTECHtor LP Gas Detector
- Q&A: What do I Need to Replace My Parallax 7300 RV Converter?
- Q&A: Lift Kit and Brackets for Top Mount Torflex 3500 lb Axles on Horse Trailer
- Q&A: Recommended Bright LED Floodlights for Rear of Horse Trailer
- Article: Trailer Wiring Diagrams
- Article: How to Measure a Trailer Axle
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)