Can The Drop Leg Pin Be Repositioned On The Bulldog 2 Speed Jack
Updated 08/30/2022 | Published 08/29/2022
Question:
Can you rotate the leg pin to the side where the crank rod comes out so its not facing forward
asked by: Elliott
0
Expert Reply:
The drop leg pin holder for the Bulldog 2-Speed Jack # BD183416 is welded on so you could cut it off and reweld it to the other side of the jack and rotate the drop leg as well, but that would require quite a bit of work.
expert reply by:
Kevin C
0
Product Page this Question was Asked From
Bulldog 2-Speed Jack - Drop Leg w/ Non-Spring Return - Planetary - 26" Lift - 10,000 lbs
- Camper Jacks
- 5th Wheel Camper
- Landing Gear
- Side-Mount Jacks
- Steel
- 9001 - 10000 lbs
- Manual Jack
- 26 Inch Lift
- Weld-On
- 1 Jack
- Bulldog
more information >
Continue Researching
- Shop: Bulldog 2-Speed Jack - Drop Leg w/ Non-Spring Return - Planetary - 26" Lift - 10,000 lbs
- Shop: Trailer Valet JXS Drill Powered Drop Leg Trailer Jack w/ Footplate - Sidewind - Side Mount - 1.8K
- Search Results: 183401
- Search Results: 183816
- Q&A: Installation Time for Blue Ox BX1128 Flat Tow Base Plate Kit for 2016 Jeep Grand Cherokee
- Article: Can I Put Wallpaper in My RV?
- Q&A: Is There a Powered Drive Kit for the Ram Square 2-Speed Jack
- Q&A: Can Electric Motor and Gear Box Be Replaced on Bulldog 12K Trailer Jack
- Q&A: Replacement Parts for Pro Series 12000 Trailer Jack
- Q&A: How to Test Brake Magnet Amperage on a Trailer with 4 Brakes
- Q&A: Replacement Brakes for an AL-KO Axle. Can I Use Heavier Brakes?
- Q&A: Replacement Bearing Solution for DICO Hub 45263
- Article: Best Bike Racks for Electric Bikes