What Gauge of Wire Between Solar Panels and Controller of GO Power Solar AE-6
Published 03/11/2022 >
Products Featured in This Question
Question:
Wiring from roof to charge controller What size wire do you need to go from your roof to your charge controller with your largest system that you offer I believe it’s like a 1600 W system? Wired in series or parallel?
asked by: Derrick
Helpful Expert Reply:
Our highest rated solar panel kit is the Go Power AE-6 part # 342-75011 which is rated for 1,140 watts. Each of the panels comes with wiring that runs to the controller so you would not need to supply that. Typically 10 gauge wire would be good.
Product Page this Question was Asked From
Go Power Industrial Pure Sine Wave Inverter Charger - 3,000 Watts - 100 Amps - 12V
- RV Power Inverter
- Pure Sine Wave Inverter
- Large Appliances
- 12V
- 3000 Watts
- Inverter/Charger/Transfer Switch Functions
- AGM
- Gel
- Lead Acid
- Lithium
- Power Center
- Go Power
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Progressive Dynamics 2000 Watt Inverter Try To Charge Batteries
- Q&A: Best Replacement For Coleman Mach RV AC Unit
- Q&A: What Replacement Converter Do I Need for a Series 7300 Model 7345 Converter?
- Q&A: Recommended Replacement for Atwood GC6AA-9E RV Water Heater
- Q&A: Recommended Replacement for Atwood GH6-6E RV Water Heater
- Q&A: Recommended Replacement Converter For A Parallax 7300 Series Power Center
- Q&A: Recommendation For Increasing Strength of Rear Bumper Attached to Spacers Off Of Trailer Frame
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Trailer Tire Sizing
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Trailer Wiring Diagrams
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer

