How to Access the Internal Components of Bulldog Square Jacks
Updated 08/14/2013 | Published 08/13/2013
Question:
I have a 2011 Gooseneck Brank stock trailer with a square, spring loaded jack welded to the front. The jack was jacked-out too far and the nut has broken and I need to replace it. It appears the nut must be threaded from the top of the screw. How do I remove the screw to get the new nut stared? Thanks
asked by: Cody
Expert Reply:
To access the gears inside of the heavy-duty Bulldog jacks, like part # BD182415 you simply remove the screws that are holding on the plate covering the top of the jack. Once that plate is removed, the gears, pins and handle should be exposed.
We also offer the Replacement Screw and Nut Kit, # BD500217, for the heavy-duty 12,000 lb capacity Bulldog jacks. I have attached two photos that show the inner workings of the heavy-duty Bulldog jacks for you to check out.
Hopefully the jack you have on your trailer is similar to the # BD182415 that you referenced and the process I described would be the same for you jack.
