Which Torklift Hitch Fits 2007 GMC Sierra Classic 2500HD Long Bed

Question

Question:

Looking for a hitch for a long bed 07 GMC2500. Will TLC1204 work?

asked by: Carl P

0

Expert Reply:

The Torklift hitch part # TLC1205 is the hitch you'd need for your 2007 GMC Sierra 2500HD long bed as the # TLC1204 only fits the short bed trucks.

expert reply by: Jameson C

0

Answer 1

The #TLC3205 you have now is only designed to work with the factory hitch. Whether it is the #DT45517, a Curt hitch, or even a TorkLift hitch you will need a different rear tie-down. The correct rear tie-down for a 2002 Silverado 2500 without a board…

view full answer...

Answer 2

Ground clearance is generally not a problem on full size trucks like your 2007 Chevy Silverado 3500. With that said the 2-1/2 inch hitches for the truck do hang fairly low. The Draw-Tite hitches #DT45519 and #DT45517 fit a little tighter to the rear…

view full answer...

Answer 3

It sounds like you are looking for a rear set of camper tie downs for your 2008 Chevy Silverado 3500 dually with the Curt hitch part #C15703. For that we have the Torklift set part #TLR3501 which I confirmed with Torklift as a fit.

view full answer...

Answer 4

Hi Jonathan, Actually, nothing will make the Curt Trailer Hitch Receiver #C15703 not fit your 2002 Chevy Silverado 2500HD if you remove the factory hitch. If you remove that hitch, you can absolutely install the #C15703.

view full answer...

Answer 5

If the tube step on your 2006 Chevy Silverado 2500 short bed is only under the cab of the truck and no part of it is attached beyond the back of the cab then you would look at the tie downs for models without a board or step under the truck bed and…

view full answer...

Answer 6

It looks like the TorkLift tie downs for your old 2004 GMC Sierra 2500 long bed were #TLC2204 for the front and #TLR3503, #TLR3504, #TLC3206, or #TLR3501 for the rear. The 2015 GMC Sierra 3500 Crew Cab long bed uses #TLC2220A for the front and…

view full answer...

Answer 7

The only other part that comes in the package of your TorkLift Custom Frame-Mounted Camper Tie-Downs - Rear #TLR3501 apart from the parts you mentioned is the metal pin/clip that attaches the tie-down shank into the receiver shank. I went ahead and…

view full answer...

Answer 8

I'm not 100 percent certain about the exact measurement you are looking for; is it the vertical measurement of the bolt hole on the frame brackets to the hitch tube itself or the horizontal measurement from the bolt hole to the rear of the hitch…

view full answer...

Answer 9

Curt Trailer Hitch Receiver #C15703 hangs pretty low on a 2005 Chevy Silverado 2500. From the bottom of the bumper to the top of the hitch receiver it is approximately 4 inches. I have included a picture showing the gap. A similar hitch, #C15302,…

view full answer...

Answer 10

I had our warehouse measure the Curt Trailer Hitch Receiver #C15703 you were looking at, and has an overall width of 40-5/8", overall length of 29". The distance between the vertical mounting holes is 14-1/2" center to center, and the…

view full answer...

Answer 11

For your 2004 GMC Sierra 2500HD we have the Draw Tite part #41944 which is a Class V confirmed as a fit for your truck once you remove the factory hitch. This will also work with your front Torklift tie down #TLC2205 but you'll need to go with a…

view full answer...

Answer 12

The Curt Trailer Hitch Receiver #C15703 that fits a 2006 Chevy Silverado 2500 will work with TorkLift camper tie-downs. These tie-downs are specific to a number of variables which you left out but assuming your '06 Silverado 2500 has an 8 foot…

view full answer...

Which Torklift Hitch Fits 2007 GMC Sierra Classic 2500HD Long Bed

Products Featured in This Question

Continue Researching