How To Pair the Rear View Safety Wireless Hitch Camera
Question:
Just purchased this camera from you and it did not come paired!! Tried pairing ....no luck Can someone walk me through it or should I return it
asked by: Gary W
Expert Reply:
I have attached the pairing instructions for the Rear View Safety Wireless Hitch Camera part # Rvs-83112 below. Please note, you must first install a 9 volt battery not provided into the camera in order for the system to work properly.
1 )Turn on camera (see step 2 above)
2)Hold power button on camera for 6 seconds until Led flashes Blue. (camera is now in pair mode for 1 0 seconds)
3)Turn on monitor (see step 3 above)
4)Push the pair button on monitor until PAIR OK is displayed
5)Restart monitor (step 3) System is now PAIRED
Product Page this Question was Asked From
Rear View Safety Wireless Hitch Camera
- Backup Camera
- Hitch Alignment Camera Systems
- Wireless Signal
- Dash Monitor
- 3.5 Inch Display
- Rear View Safety
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Horse Trailer Ramp Spring For Helping Lift Heavy Ramp
- Article: 2023 Best Gifts for Auto Enthusiasts
- Article: Trailer Wiring Diagrams
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Trailer Maintenance Schedule
- Article: 2023 Holiday Must Haves
- Article: 2023 Best Gifts for Haulers & Towers
- Q&A: Modern Tire Size Equivalent for 20.5x8-10
- Q&A: Can the Gen-Y Hitch 5th Wheel to Gooseneck Pin Box Be Used in a Short Bed Ram 3500
- Q&A: Curt True Course Compatibility with 2017 Ford F-350 and Triple Axle Toy Hauler
- Q&A: Bike Rack that Can Attach to Top of BAK MX4 Hard Tonneau Cover
- Q&A: Recommended Blue Ox SwayPro Weight Distribution System for Travel Trailer With 640 lb Tongue Weight
- Q&A: Can Group 24 and Group 27 batteries be Wired Together in Parallel