How Far Does the handle Stick out on Bulldog Trailer Jack # BD195369
Updated 02/15/2013 | Published 02/13/2013
Question:
i working on an engineering project that I am using this jack. I saw on the demo page that the radius of the handle is 6 1/2 inches. I am assuming center to outside of handle. but what I would like to know is what is the distance of the handle form the face of the tube to the outside of the handle in the horizontal direction?
asked by: Doug
Helpful Expert Reply:
I suppose that since you are using this jack but are asking for the measurement that you do not actually have the jack present. So I will be happy to help you. There is a little bit of play in the handle but when measuring from the side of the jack out to the end of the handle it will be at least 4-5/8 inches and at most 4-7/8 inches. I made a picture showing the measurement for you.
Product Page this Question was Asked From
Bulldog Square Jack - Fixed Leg - Sidewind - 15" Lift - 3,000 lbs
- Trailer Jack
- Enclosed Trailer
- Utility Trailer
- Side-Mount Jacks
- Standard Grade
- 2001 - 3000 lbs
- Manual Jack
- 15 Inch Lift
- Weld-On
- No Wheel or Foot
- Bulldog
more information >
Continue Researching
- Q&A: Recommended A-Frame Trailer Jack for 7000 lb Trailer
- Article: Practice Safe Trailer Towing with These 4 Tips
- Q&A: Mounting Suggestion For E-track To Aluminum Utility Trailer
- Q&A: Torsion Spring for Trailer Ramp Door that Weighs 200 lb
- Article: Trailer Tire Sizing
- Q&A: Can the Handle on Bulldog Square Jack # BD190751 Be Installed from Either Side
- Q&A: Replacement 12 Inch Brake Assemblies Compatible with Old Warner Trailer Hub/Drums
- Q&A: What is the Inside Measurement of the Replacement Drop Leg for etrailer and Ram Square Jacks?
- Q&A: Will Replacement Drop Leg for etrailer and Ram Square Direct Weld Jacks Fit Jack # MJSQ-2500B