Wire Loom to Use With Bulldog Powered-Drive Kit for Single-Speed Jacks w/ 12,000-lb Capacity
Updated 11/24/2020 | Published 11/21/2020
Products Featured in This Question
Question:
What size cable clamps do I need to order to secure the wiring loop to the side of the trailer? Id like to order everything at one time so I can get the install done quickly.
asked by: Richard
0
Expert Reply:
To secure the wire loom of the Bulldog Powered-Drive Kit for Single-Speed Jacks w/ 12,000-lb Capacity # BD1824200100 you would want to use the cable clamp part # SWC8925-1 which has an inner diameter of 7/8 inch.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Bulldog Powered-Drive Kit for Single-Speed Jacks w/ 12,000-lb Capacity
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Motor and Gear Parts
- Powered-Drive Kit
- Bulldog
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Do You Have a Gooseneck Hitch for a 2021 Chevy Silverado 5500?
- Q&A: What Is The Correct Tube Dimension On The Dexter DX32CR?
- Q&A: What Curt Helux do I Need to Replace My MORryde RPB72-FD Lippert Rhino Pin Box?
- Q&A: Dimensions Of The Stromberg Carlson Adjustable RV Trailer Hitch
- Q&A: Can Replacement Left/Curb Side Leg e63VV Be Used As A Standalone Jack
- Q&A: Replacement Idler Hub For a 2017 Triton LTWCI-T Boat Trailer With 2,000LB Trailer Axle and Knott Hub
- Q&A: Wiring Diagram for the Bulldog Powered-Drive Kit # BD1824200100
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Ram Trailer Tow Prep Package
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: How to Charge a Dump Trailer Battery
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Trailer Maintenance Schedule