Hitch for 2018 Buick Regal Sportback
Updated 07/18/2020 | Published 07/17/2020
Question:
i need to know if this hitch fits my 2018 Buick Regal sportback and if the installation guide helps specifically with my car? and is it able to be done without raising the car?
asked by: Brett D
Helpful Expert Reply:
The Draw Tite hitch part # 36652 that you referenced is a confirmed fit for your 2018 Buick Regal Sportback and does come with install instructions that are specific for your vehicle. I attached an install video for this on the Chevy equivalent too for you to check out as well. Install is not overly difficult but it does require removing the rear bumper fascia.
A lift would not be needed to install this either. We use a lift in our install videos as it makes it easier to show in the video.
Product Page this Question was Asked From
Draw-Tite Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4"
- Trailer Hitch
- For Towing
- Class II
- 350 lbs TW
- 3500 lbs GTW
- 1-1/4 Inch Hitch
- Concealed Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Recommended Hitch for a 2023 Chevy Malibu
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: How to Choose the Right Trailer Hitch Class
- Article: How Much Does a Boat and Trailer Weigh?
- Q&A: Which Vehicle Wiring Harness Do I Need for a 2019 Chevrolet Malibu?
- Q&A: Picking Out Axle Over Under Kit for Al KO 3500 lb Axle
- Q&A: Trailer Hitch Receivers Confirmed To Fit a 2020 Mercedes-Benz GLE 350
- Q&A: Will Tekonsha Wiring Harness Fit 2024 Kia Telluride S
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What Hitch Pin Lock Works With The Benton Bike Rack B54VR
- Article: Trailer Wiring Diagrams
- Article: Best Bike Racks for Electric Bikes