How To Mount Two Friction Sway Control Bars On a Ball Mount

Updated 07/17/2020 | Published 07/15/2020

Products Featured in This Question

Reese Friction Sway Control Kit - Economy - by Draw-Tite, Reese and Hidden Hitch

(486)

$74.51

Weld-On Sway Control Tab

(37)

$13.44

Curt Ball Mount w/ Sway Control Tab for 2" Hitches - 3/4" Rise, 2" Drop - 7,500 lbs

(173)

$46.73

Question:

Hello, I am looking at the Reese Friction Sway Control Kit - Economy - by Draw-Tite, Reese and Hidden Hitch, I am planning on purchasing a ~32ft trailer and figure I would want/need two of these installed together but Im confused about where the 2nd would connect..is there another bracket that has not one but two balls for this to connect to? I know the normal recommendation is a weight distribution hitch that also has sway control BUT my tow vehicle manual specifically says not to use a Weight Distribution hitch. Any help would be appreciated Thank you! Tow Vehicle: 2019 Land Rover Discovery 3.0 Turbo Diesel

asked by: Adolfo

Expert Reply:

In order to use two friction sway control bars like the Reese Friction Sway Control Kit part # 83660 you'd need to have two of the friction sway control tabs like the Weld-On Sway Control Tab part # C45822 welded to the ball mount. The other options would be to use the Curt Ball Mount part # D320 assuming it has the correct rise/drop for you needs and only have one friction sway control tab welded on.

expert reply by: Conner L