Difference Between Putco Fender Trim for 2019 Ram 1500 Classic

Question

Question:

P97190 and P97191. What is the difference between the above two fender trims?

asked by: William J

0

Expert Reply:

Good question, and the difference between the two fender trims for your 2019 Ram 1500 Classic are what they specifically fit.

The Putco Stainless Steel Fender Trim for Dodge Ram - Full # P97190 will fit all models unless they have the factory add-on fender flares.

The now-discontinued Putco Stainless Steel Fender Trim for Dodge Ram - Full P97191 was designed to fit Sport models.

I have added a link to the instructions for you to take a look at as well.

expert reply by: Kyle S

0

Answer 1

I reached out to my contact at Putco who said that their fender trim, like the Stainless Steel #P97190 for your 2011 Ram 1500 measures 1-1/2" - 2" wide.

view full answer...

Answer 2

For stainless steel front and rear fender trim that fits your 2012 Dodge Ram 1500 we have the Putco kit part #P97190 as a confirmed fit. It is a bit wider than 1/2 inch though as it varies in width between 1-1/2 inch and 2 inch.

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 7

To install a Redarc Tow Pro Liberty in your 2023 Toyota Tacoma Sport you will need the following parts: Redarc Tow-Pro Liberty Brake Controller item #RED24FR Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers item #RED99FR…

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 10

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 11

Hey Melanie. The reason you can't find a replacement for your GE ARC15AACBL2 15,000 btu air conditioner is because they phased them out. In 2025 all RV AC systems had to change over to a new coolant called R32. This was a EPA mandated decision.…

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Difference Between Putco Fender Trim for 2019 Ram 1500 Classic

Continue Researching