How to Program PIDs on Edge Insight CS2 to Display EOP and EOT
Published 10/31/2019
Question:
How can I program PIDs to display these parameters?
asked by: ElSakka, W
Expert Reply:
The Edge Insight CS2 # EP84030 that you referenced can be programmed to display the engine oil pressure or engine oil temperature on your Jeep Grand Cherokee by going through a few steps.
Looking at the gauge layout screen, press the ENTER button and you will see a gauge location highlighted. Then use the arrows to highlight the particular gauge location you need to modify. Highlight and select NEW PID option, then press enter.
From here use the up/down arrows to highlight a new PID (you might need to scroll a bit or go to the next page to find the EOP and EOT). Doing this should show the new PIDs with any other options you may have changed already.
Product Page this Question was Asked From
Edge Insight CS2 Comprehensive Gauge Display - Color Screen
- Performance Chip
- Monitors
- Color Screen
- Yes - California Approved
- Insight
- Edge
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Best Air Bag Kit For 2026 Ram 3500 With In-Bed Hitch
- Article: Performance Chips and Modules
- Q&A: Parts Needed To Install 7-Way On a 2013 Chevrolet Express 2500 Passenger Van
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Anti-Rattle Devices
- Q&A: Trailer Hitch and Wiring for a 1997 Dodge B3500 Full Size Van
- Article: Rooftop Cargo Carriers
- Q&A: What Rear Anti-Sway Bar Fits a 2014 Chevy Silverado 2500 w/o a Factory Sway Bar?
- Article: How to Measure for Trailer Hitch Drop
- Article: Gooseneck to 5th Wheel Adapters
- Q&A: Is there a Gooseneck Hitch for a 2024 Ram 2500 w/out the Factory Prep Package?
- Q&A: Hitch and Wiring that Will use the Factory 7 and 4 Way Plug on the Bumper for 2019 Toyota Tacoma
- Q&A: Trailer Hitch Receiver for 2019 Toyota Tacoma With 2.7L Engine
- Article: 5 Things to Know About Weight Distribution Hitches