Can Fulton Hi Mount Spare Tire Carrier Fit 14 inch Wheel with 5 Lug Bolt Pattern  

I have another option for you, but the Fulton Hi-Mount Spare Tire Carrier #FSTC1000301 you were looking at only works with 4 and 5 bolt wheels, and will not work with your wheels that have the 6 on 5-1/2" bolt pattern. Instead I recommend the…

As long is your tire is larger than 10 inches in diameter and your trailer frame member is no more than 3 inches wide and 4 inches tall, the Fulton Hi-Mount Spare Tire Carrier # FSTC1000301 will carry your wheel/tire with a 5 on 4-1/2 bolt pattern…

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

The opening on the Yakima HandRoll Kayak Roof Rack #Y04082-2 isn't tall enough to completely clamp around the crossbars on the #MPG475. Yakima said that you can still use it if it is clamped onto the side but you will have to make sure it is…

Thank you for providing all the information. If you are going to replace your entire idler hub you would want the Stainless #KH84545S or Galvanized #DE36VR idlers hubs since its on a boat trailer. These will come with the Inner Race #L68111 and Outer…

Hey Jon, so the Bearing Buddy seal kit part #BB60002 that you referenced is the correct fit based on your bearing numbers.

While we do not carry a replacement cap which will allow you to convert your hubs from oil bath to grease we do have a hub and all the components you will need to install a new setup which can be filled with grease. You will need one of each per hub.…

For a spare tire and wheel on your 2023 Coleman Lantern 17B use the Karrier ST215/75R14 Radial Trailer Tire - 5 on 4-1/2 - Load Range C - Galvanized Wheel #AM32182 or White Wheel #AM32181.

Since your old V-bar light only uses a single wire it grounds the light through the mounting hardware. You will simply need to add a Ring Terminal #DW05736-1 to the ground wire on the V-Shaped Identification Light Bar #TN23MR. Then you will be able…