What Type of Hole Does Anti-Rattle Star Pin Locking Fasteners for License Plates # CR81420 Fit
Updated 04/04/2019 | Published 04/03/2019
Question:
What size holes do I need to drill for the nylon fasteners? Thx
asked by: Jeff
0
Expert Reply:
The Anti-Rattle Star Pin Locking Fasteners for License Plates and Frames # CR81420 is designed to fit the standard square hole size found on license plate brackets. You wouldn't be able to use a drill to create these square holes.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Anti-Rattle Star Pin Locking Fasteners for License Plates and Frames - Standard - Qty 4
- Accessories and Parts
- License Plates and Frames
- Fasteners
- Locking
- Rattle Stop
- Standard
- Cruiser
more information >
Continue Researching
- Q&A: Replacement For Dexter E-Z Flex Equalizer 13-144
- Q&A: Replacement Motor for Atwood Landing Gear
- Q&A: Husky Electric Tongue Jack Will Lower But Not Raise
- Q&A: Parts Needed to Add 5-Way to 2019 BMW X5
- Q&A: Why Does 4-Pin Trailer Wiring Have 5 Wires
- Q&A: Wiring New 4-Way Connector on Trailer with 5 Wires
- Q&A: Recommendation To Replace Slipper Spring And Bushings
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams