What Size Hole Do I Need To Drill To Run the Wire for the LED Light Strip Kit
Updated 03/27/2019 | Published 03/25/2019
Products Featured in This Question
Question:
what size would I need to drill through my camper exterior wall to run the wiring inside? It looks like the ends are pre-installed on the wiring.
asked by: Robert A
Helpful Expert Reply:
I went out to our warehouse for you and measured the connector that attaches to the end of the LED light strip on the LED Light Strip Kit with Wireless IR Remote part # DG52688. This connector is just under 1/2" at it widest point so you will need to drill a 1/2" diameter hole into the exterior of your trailer in order to run the connector through. In order to prevent any sharp edges on the trailer's exterior walls from piercing the jacket on the above wire you will want to use a grommet in the hole part # SWC8075-1.
The ends of the harness that run to the light strip from the control box are plug and play and so is the rest of the kit save for the 12 volt power connection (if used).
