Installation of Trailer Wiring Harness for 2013 Acura RDX
Question:
Hello. I just purchased and installed a Draw-Tite Class III Max Frame Receiver Hitch 75784 for my 2013 Acura RDX. In the product description on your website it says It may be necessary to see a local Acura dealer for a relay. The relay is needed to activate the tow package wiring circuit. - Could you let me know a little bit more what this means? - Is a a relay in addition to the wiring harness I would need to get? - Is the relay just a part that I can only get from them, or are they the only ones that can install it plus the wiring harness, etc? Thanks!
asked by: Greg B
Helpful Expert Reply:
For your 2013 Acura RDX, the wire harness for a trailer connection needed is the T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector # 118569. There is a fuse required that comes with this kit that needs to be installed in the fuse box under your hood. There will be a fuse position labed (20A ) Trailer.
If this does not activate your trailer wiring, then there is a relay that will need to be obtained from your Acura dealer. Most vehicles already have the needed relay and just need the fuse and harness.
I've attached the installation details and a video to assist.
Products Referenced in This Question
T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Powered Converter
- Custom Fit
- 4 Flat
- Tekonsha
more information >
Product Page this Question was Asked From
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 400 lbs TW
- 4000 lbs GTW
- 2 Inch Hitch
- Concealed Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: Recommended Bike Rack For Hauling 4 Bikes On A 2014 Acura RDX
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Can Trailer Hitch Be Installed On 2005 Chevrolet Colorado With Rear Pan Installed
- Q&A: Replacement Installation Hardware Kit for Draw-Tite Trailer Hitch 75607 on a 2009 Chevy Colorado
- Q&A: Install Instructions for Draw Tite Hitch # 75784 for 2015 Acura RDX
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Clean Weld Nuts for the Installation of a Trailer Hitch | etrailer.com
- Q&A: Where to Jack Up a 2014 Acura RDX to Install a Trailer Hitch
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Recommended Trailer Wiring Harness for 2017 Acura RDX
- Q&A: Difference Between Curt and etrailer Trailer Hitch Receivers for 2020 Chevy Colorado
- Article: How to Choose a Hitch-Mounted Bike Rack
- Article: Performance Chips and Modules