2 Inch Ball Mounts with 4 Inch Drop Compatible with Reese Sway-Control Bracket

Updated 08/01/2018 | Published 07/31/2018

Products Featured in This Question

Reese Sway-Control Bracket for 2" Ball Mounts - Class III and IV

(319)

$44.40

Draw-Tite Ball Mount for 2" Hitches - 2-3/4" Rise, 4" Drop - 9" Long - 7.5K

(3471)

$38.63

Convert-A-Ball Ball Mount for 2" Hitches - 2-3/4" Rise, 4" Drop - 10,000 lbs

(1354)

$83.22

Curt Dual Length Ball Mount for 2" Hitches - 2-3/8" Rise, 3-5/8" Drop - 7,500 lbs

(162)

$53.23

Question:

I received this part and immediately discovered my drawtite 4281 ballmount is too wide 3 for it to fit. How do I determine the width of any given ballmount that you sell? That specification does seem to appear on the ballmount description. I need a 4inch drop 7,500 or more GTW ball mount with 1inch shank hole for 2inch receiver. Can you list every ball mount that meets that description?

asked by: Alan W

Helpful Expert Reply:

As you mentioned in your question, the Reese Sway-Control Bracket # RP26003 requires the ball mount platform it is used with to be narrower than 2-5/8 inches.

I narrowed down our available selection of ball mounts to those that meet your requirements (2 inch hitch, 4 inch drop, 1 inch ball hole, 7,500+ pound capacity) and then went out to our warehouse to measure the ball platform widths on these units. I found that the following ball mounts match what you are needing and feature a ball platform narrower than 2-5/8 inches for use with your Sway-Control Bracket.

Convert-A-Ball Ball Mount # AMSC4

Draw-Tite Ball Mount # 2753

Curt Ball Mount # C45230

I have also attached a video demonstration for each of these ball mounts that you can check out.