Uninstalling Fireplace Model F2611E to Troubleshoot Operation

Question

Question:

The fireplace will not come on. I have replaced the fuse and its still not working. The troubleshooting says to unplug the unit as it may havre overheated but I cannot find any means of removing the trim/unit from the wall in my RV???Model # F2611E Can you assist?

asked by: Dave K

0

Expert Reply:

For your Greystone 26" Curved Electric Fireplace with Remote Control # WF2613L (model F2611E) the trim simply lifts up to allow access to the mounting screws. I've attached a video to assist.

If unplugging the unit doesn't work, then I recommend checking the function of the unit in another outlet. Not all manufacturers use the proper wire gauge for the outlets required by the manufacturer and that can be an issue. You want 14 gauge wire minimum like # DW02422-1 for that particular outlet. I recommend going with 12 guage # 12-2-1.

expert reply by: Jason S

0

Answer 1

There are flags going up as soon as you say there is no white wire, because white is traditionally the ground and you absolutely will need a ground for everything to work. So, you will need to determine function based on location and not on color.…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 4

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 5

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 6

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 7

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 8

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 9

The Demco Hydraulic Trailer Brake Actuator part #DM72VR should be a direct replacement for the Atwood 61101 Brake Actuator that you have now. This newest updated it rated at 7K instead of 6K. This is a bolt on option that mounts on 3" centers.…

view full answer...

Answer 10

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 11

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 12

Hey Robert, yes the Kodiak disc brake calipers part #KDBC225DAC that you referenced will replace the Tie Down calipers you have now 46304, they can be used as a left or right hand caliper and does come with ceramic brake pads. If you ever needed…

view full answer...

Uninstalling Fireplace Model F2611E to Troubleshoot Operation

Products Featured in This Question

Featured Help Information

Miscellaneous Media

Continue Researching