How To Attach 4-Way Trailer Connector To Hitch of 2011 Toyota Sienna

Published 08/24/2011

Products Featured in This Question

T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector

(296)

$81.52

Mounting Bracket 4-Pole Flat

(6189)

$10.37

Question:

How can I have the connector mounted on the hitch as an OEM setup? I dont want the connector wire in the trunk and hanging out when in tow. What other adaptor/kit that you sell will make this happens? Thanks.

asked by: H L

Expert Reply:

When using a 4-way setup on your 2011 Toyota Sienna like the Tow Ready Custom Fit Vehicle Wiring, part # 118498, you can use a 4-way mounting bracket on your hitch.

You will want to use the Mounting Bracket 4-Pole Flat, part # 18144 and the No-Drill Mount Bracket, part # 18140. This will attach to the hitch on your Sienna and give you a clean factory look.

However, you will need to route the 4-way wiring down below the tail light housing and down, behind the rear bumper, then attach to the bracket on the hitch.

I have linked instructions for the Tow Ready Custom Fit Vehicle Wiring, part # 118498 and video installations of the Mounting Bracket 4-Pole Flat, part # 18144 and the No-Drill Mount Bracket, part # 18140.