Recommended Rear View Camera Connection with RCA Adapter for Monitor
Updated 01/15/2021 | Published 04/20/2018
Products Featured in This Question
Question:
I’d like to connect the video output to my Edge CTS2 monitor that has a RCA video in port. Is there an adaptor to connect the Hopkins 8 pin harness to an RCA jack? This would allow me to have one less monitor screen on my dash as I could do away with the small Hopkins video screen provided.
asked by: Craig
0
Product Page this Question was Asked From
Hopkins Smart Hitch Backup Camera and Hitch Aligner System
- Backup Camera
- Hitch Alignment Camera Systems
- Hardwired
- Dash Monitor
- 3.5 Inch Display
- Hopkins
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Backup Camera that Will Plug In Line with a 7-Way Trailer Connector on a 2005 Toyota Tundra
- Q&A: Replacing 6-Way on Trailer With 7-Way Connector
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Q&A: Maximum Tongue Weight for B&W Digital Tongue Weight Scale
- Q&A: How Accurate is the 1,000 lb BTBRV Tongue Weight Scale
- Q&A: How to Tell the Difference Between a 4-Bolt and a 10-Bolt 5th Wheel Hitch Mounting Rail
- Q&A: Comparing the Andersen Weight Distribution Systems To Friction Bar Systems
- Article: Performance Chips and Modules
- Q&A: Will etrailer Hitch Block Hands-Free Liftgate Sensor on Toyota Sienna
- Article: Rooftop Cargo Carriers
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today
- Article: Trailer Wiring Diagrams
Nathan G.
1/10/2021
I have the Hopkins backup camera and I would like to run it to my receiver in my truck is there an adapter that will go from that 8 Pinn to an RCA on my stereo