Can Two Sets of the Prostrobe Intimidator 2 Safety LED Lights be Wired Together
Updated 03/06/2018 | Published 03/05/2018
Question:
Is it possible to connect two sets of these lights together to have a four set unit that the controller that plugs into the cig. outlet will work the four LEDs// Thanks
asked by: George C
Expert Reply:
I do have a solution for you, however I do not recommend wiring two of the Prostrobe Intimidator 2 Safety LED Lights # PRS70726 together. My contact at Prostrobe said that doing this can permanently damage the control box and will also void the product's warranty. The built-in resistor on the control box is only designed to operate the 2 LED's that are included with the unit.
What you can do though is operate two of these sets that are wired separately with the same wireless controller. The controller will just need to be "re-sync'ed" to the added control box. To do this, you will just need to follow these steps:
After installing and wiring both control boxes for the two sets of LED Lights, place the remote you want to use to operate the strobes in a 12V power outlet or cigarette lighter outlet, but do NOT power on. Then hold the clear button on the side of each black control box (one per each strobe set) until both control box buttons show a red LED. Within 45 seconds of this happening, push the power button on the remote. This should pair the remote so that it controls both sets of strobe lights.
