Hitch Bolts Seem Too Large for the Weld Nuts in the Frame on a 2000 Toyota Camry

Published 06/24/2011

Products Featured in This Question

Draw-Tite Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4"

(361)

$217.20

Battery Post and Terminal Cleaner - Wire Brush

(15)

$5.02

Question:

The class II hitch purchaced is suppose to be the exact hitch for the 2000 camry that I have. The bolts provided with the hitch DO NOT fit the pre drilled holes in the camry frame. The bolts provided are bigger than the holes. Is there any way to to determine the correct size of bolt needed for the pre threaded camry frame? I cannot figure it out. Thoe bolts sold at the local stores also do not thread into the holes.

asked by: Charles G

Expert Reply:

The bolts provided with the Draw-Tite Trailer Hitch, # 36336, are the correct bolts for your 2000 Toyota Camry, see instructions link. You are most likely running into corrosion from road grime and salt since your vehicle has some age. We have help videos, see links, that detail how to go about cleaning the vehicles weld nuts for installing the hitch.

You may find that a weld nut will break off when trying to install the hitch, despite your best efforts, if this happens we have a video detailing how to remove the weld nut and install correctly sized hardware in the frame of the vehicle.

Check out the articles and videos I have provided, they will assist you with installation of your hitch and you will be up and towing in no time.

expert reply by: Robert G