Brake Controller Recommendation for 2007 Holiday Rambler Endeavor
Published 12/19/2017
Question:
What harness number do I need for a for prodigy controller to fit a 2007 holiday rambler endeaver
asked by: Mike
Expert Reply:
The brake controller wiring you need is terminated in a connector under the left side control panel next to the driver seat of your 2007 Holiday Rambler Endeavor. There is no quick install harness for your RV though. There should be a cover on the vertical side of the panel facing the driver seat and the connector will be behind it. There should be a 12 volt power wire (run black wire here), a ground wire (white wire), a brake switch wire (red wire) and a brake output circuit (blue wire) there.
For a brake controller I would recommend the Prodigy P3 Brake Controller part # 90195. This is our best selling brake controller because of how well it works and how easy it is to setup. This is a proportional brake controller that senses the amount of braking the tow vehicle is applying and applies a proportionate amount to the trailer brakes. This will be the last brake controller you buy. It can easily be transferred to future vehicles as well.
