How to Mount a Bargman Surface Mount Tail Light # 30-92-107
Updated 06/03/2011 | Published 06/01/2011
Question:
Truck is 4x4 s10 crew cab 2001. Coleman 1991 pop up camper. The taillights were installed with a rivet gun and it is inclosed, no axcess. New kit has no instructions. I dont know how to remove old, install new or how to wire it. help!! not sure what to do. thanks Kit info is Bergman 30-92-107
asked by: Kathy
Expert Reply:
To remove rivets you will need to drill them out with a drill bit that is slightly smaller than the rivet.
I spoke with my contact at Bargman about the proper way to install the Bargman Surface Mount Tail Light, part # 30-92-107, and he informed me that you will need to remove the lens from the unit and then you will take screws and run them through the holes in the four corners of the mounting plate from the inside out and mount the unit to the surface by drilling these screws into the surface of the trailer. From there you will re-install the lens on the light and you will be ready to wire the unit up.
Both of the white wires will need to be grounded.
The black wire will need to run to the running light circuit.
The green wire will need to be run to the stop/turn circuit.
The red wire will need to be run to the reverse light function if available.
