Recommended Torque for Locking Out a Reese Revolution Pin Box
Updated 09/25/2017 | Published 09/24/2017
Question:
what is the torque required to install the 3/4 inch lock out bolts on a reese revolution.
asked by: Tom
0
Expert Reply:
I spoke with my contact at Reese who said that the 3/4", 10 by 2" bolts used to lockout your (or any) Reese Revolution pin box should be torqued to 210 lb-ft. You will also need to make sure that you are using a conical washer and that you remove the wedge.
expert reply by:
Jon G
0
Continue Researching
- Shop: Replacement Gas Strut for MORryde StepAbove RV Steps with Strut-Assist - Qty 1
- Q&A: Torque Recommendation for Pin Box Bolts
- Q&A: Torque for Lippert 1621 Pin Box
- Search Results: sidewinder
- Q&A: Lock Out Bolts Required for 5th Airborne Sidewinder to Have Standard Conventional Towing Ability
- Q&A: Correct Replacement Wet Bolt for 2022 Grand Design Solitude 5th Wheel
- Q&A: Torque and Grease Specs for Sidewinder Pin Boxes
- Q&A: What Size Hardware is Needed to Lock Out Sidewinder Pin Box
- Q&A: Where to Get Lock Out Bolts for a Reese Sidewinder Pin Box
- Shop: Equalizer Suspension Bolt 4-1/2" Long - 3/4" Diameter
- Shop: Replacement Wedge Block for Lippert Turning Point Pin Box
- Shop: Replacement 3/4"-16 UNF-2B Hex Nut for Firestone Ride-Rite Air Helper Springs Kit - Qty 1