How to Install the Curt Class II Trailer Hitch C12253 on a 2002 Lincoln LS

Published 05/03/2011

Products Featured in This Question

Curt Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4"

(5)

$266.56

1-7/8" Hitch Ball - 3/4" Diameter x 1-9/16" Long Shank - Chrome - 2,000 lbs

(2621)

$16.53

2" Hitch Ball - 3/4" Diameter x 1-9/16" Long Shank - Chrome - 3,500 lbs

(2621)

$18.47

Drawbar for 1-1/4" Hitch - 2-5/8" Rise, 3-1/4" Drop - 7-3/16" Long - 3.5K

(2328)

$29.12

Question:

How do I install this hitch on my Lincoln ls 2002?

asked by: Robert L

Expert Reply:

We have installation instructions online, see link, for the Curt Class II Trailer Hitch, item # C12253. Installation will require disconnecting rear fascia tabs, fishwiring fasteners into the frame rail, applying Galvanic isolator shields to the blocks and hitch tabs that contact the aluminum bumper, raising hitch into position, and attaching to forward fasteners, drilling two 7/16 inch holes, fishwiring bolts to rear holes, tightening hardware to specific torque recommendations and reattaching the lower fascia tabs.

You may also need to trim a small area of the lower fascia panel depending on the configuration of your 2002 vehicle. This area will not be visible once the hitch is installed.

Some items you may need to complete your Class II towing setup are listed below.

Curt T-Connector Vehicle Wiring Harness, item # C55373
Class II Drawbar, item # 36071
Tow Ready Ball 1-7/8 inch, item # 19256
Tow Ready Balls 2 inch, item # 19258