Where is the Connector Needed to Install a Hopkins Wiring Kit # 43105 in a 2003 Acura TL
Updated 04/11/2011 | Published 04/09/2011
Question:
I cant find it on my Acura TL Types S 2003 Thanks in advance.
asked by: Bob Z
0
Expert Reply:
The OEM connector that you need to find to install the Plug-N-Tow TM Vehicle Wiring Harness, part # 43105, is located in the trunk behind the driver side taillight access panel.
The access panel is the piece of the interior that you would remove if you were trying to replace the tail light bulb.
It might not be in plain view, you might need to reach in there and see if you can feel around for it.
I attached the installation instructions for this product below for you to check out.
expert reply by:
Jameson C
0
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Maximum Towing Capacity of a 2005 Honda CR-V
- Q&A: Hopkins Trailer Wiring Harness Fit For 2021 Subaru Crosstrek Non-Hybrid
- Q&A: Parts Needed to Tow a Trailer with 2018 Subaru Outback
- Q&A: Recommended Hitch for a 2014 Acura TL
- Q&A: Timbren Suspension Enhancement Fit for 2018 Newmar Bay Star
- Q&A: Length of Timbren Front Suspension Enhancement for 2006 Ford F-53 - EMAIL
- Q&A: Flat Tow Setup For A 2006 Honda Pilot
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Stability Control for Heavy Duty Vehicles
- Article: Trailer Wiring Diagrams
- Article: Flat Towing Package for 2012-2014 Honda CR-V
- Article: Trailer Maintenance Schedule