Programming Instructions for Hand-Held Remote for the Tekonsha Prodigy RF Trailer Brake Controller  

Question:

Expert Reply:

I can certainly provide you will a link to the installation details for the Tekonsha Prodigy RF, # TK94FR. It includes the pairing instructions for the hand held unit. I have also included the steps below. You may also be interested in adding a Hand-held Remote for Tekonsha Prodigy RF Brake Controller, # 90251, to use in your second vehicle.

Synchronization of the Remote Hand Held Unit to the
Power Module:

1. Connect trailer to tow vehicle.
2. Plug the Power Module 7-Way cable into the tow vehicle.
3. Trailers 7-Way connector must be disconnected from the Power Module.
4. Start vehicles engine. (Some vehicles require Key On to supply power to the 7-Way connector or Auxiliary Power Port)
5. Plug the Remote Hand Held Unit into an auxiliary power source within easy reach of the operator.
6. Turn the Power Knob to minimum position, Flashing 0.0.
7. Fully depress and hold both the MANUAL OVERRIDE and BOOST BUTTON. The display will start from P.5 and end at P.A. Once P.A has been achieved, the Manual and Boost can be released.
8. Press and hold the brake pedal until the display shows flashing 0.0. for a correct pairing.
9. Set the Power Knob to greater than minimum. Display now flashes n.c. (not connected).
10. Re-connect the Trailer 7-Way connector to the Power Module. Display should now be .c. (connected).

NOTE: To properly identify your trailer during pairing, the 7-Way trailer plug must be disconnected from the Power Module.

expert reply by: Michael H

0