Replacing Bargman AILRST 94 Tail Lights with LED Assemblies on Trailer

Question:

I have a 2094 Holiday Rambler Alumascape. I would like to replace the original tail lights with LEDs. I currently have Bergman AILRST 94 that uses a single 1157 bulb.

0

Expert Reply:

Based on the number you provided, it sounds like you have the Bargman 92/94 series taillight. These assemblies have dimensions of 8-9/16 inches long, 4-9/16 inches wide and 2-1/8 inches thick. I recommend verifying these measurements on your existing unit.

There is not a direct LED replacement assembly for these tail lights, but we do have some options that have similar dimensions. I recommend looking at the Optronics Low Profile RV Tail Light # RVSTL60 for the passenger side and # RVSTL61 for the driver's side. These lights measure 8-11/16 inches long, 3-3/16 inches wide and 2-1/8 inches deep.

I have attached a video demonstration on this product for you to check out as well as a link that will take you to our available selection of red LED trailer lights.

expert reply by:
0
Chris R

Products Referenced in This Question


Product Page this Question was Asked From


Follow up Questions

Similar Expert Q&A Pages

See More Q&A Expert Answers >>