Trailer Wiring Connection Points for a 2010 Cadillac CTS Wagon
Updated 03/28/2011 | Published 03/26/2011
Products Featured in This Question
Question:
My installer can not locate where driver side wiring access is for light wiring for trailer hitch.
asked by: Craig M
Expert Reply:
The correct wiring for a 2010 Cadillac CTS is the Tow Ready Custom Fit Vehicle Wiring, # 46255. The connection points for this harness are located behind each of the tail light assemblies. In a sedan, you would pull back the trunk lining to gain access to the back of the tail lights. But on a wagon, either the tail light assemblies will need to be removed or there may be an access panel in the cargo area that needs to be taken off in order to reach the connection points.
I have included a link to the installation instructions and a video showing a typical installation for you to view.
Product Page this Question was Asked From
Draw-Tite Sportframe Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- For Towing
- Class I
- 200 lbs TW
- 2000 lbs GTW
- 1-1/4 Inch Hitch
- Visible Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Trailer Hitch
- Shop: Draw-Tite Sportframe Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Q&A: Trailer Hitch Recommendation for a 2010 Cadillac CTS
- Q&A: Correct Wiring Harness for 2012 Cadillac CTS Coupe
- Q&A: Wiring Diagram For the Replacement Single Zone Thermostat for Dometic RV ACs
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Looking For Replacement Brakes And Hubs For An Al-Ko 7210 Axle
- Q&A: Parts Needed To Install a 7-Way and Trailer Brake Controller On a 1996 Ford F-350 With Factory 4-Way
- Q&A: Replacement For A Dometic Duo-Therm 3104998 Controller
- Q&A: Recommended Brake Controller and Installation on 2021 Toyota RAV4