Where To Connect The Tow Ready T-One Wiring Harness # 118490 On A 2010 Volkswagen Routan
Published 03/10/2011
Question:
Does the 2010 Routan have pre wired connection point for the trailer plug
asked by: Tom C
Expert Reply:
To install the Tow Ready T-One Wiring Harness, part # 118490, on your 2010 Volkswagen Routan you will plug the T-One connectors into the back of your tail light connectors. The T-One connector with the yellow wire will plug into the back of the tail lights on the drivers side and the T-One connector with the green wire will plug into the back of the tail lights on the passenger side.
The separate white wire will need to be grounded to a good, clean piece of metal like the vehicle frame.
The only remaining thing to do is to run the 4-flat trailer connector through a grommet in the jack storage area.
I am including a link to the installation instructions on the Tow Ready wiring harness.
Continue Researching
- Q&A: Recommended Trailer Hitch for a 2010 Volkswagen Jetta Wagon TDI
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Which Trailer Hitch Receiver Fits a 2011 Volkswagen Jetta TDI
- Q&A: Hitch that Fits 2009 Jetta Sedan TDI
- Q&A: Replacement Leaf Spring for 2014 Forest River Flagstaff Mac 205 Pop-Up Camper
- Q&A: How to Remove Rear Taillights on a 2012 VW Routan to Install Tow Ready Trailer Wiring # 118490
- Q&A: Parts Needed to Wire a 2012 Volkswagen Routan with a 7-way Socket for Trailer Brake Operation