Recommendation for a Trailer Side 4-Way Flat Connector on Trailer Towed by 2006 Toyota Highlander
Updated 02/28/2011 | Published 02/26/2011
Products Featured in This Question
Question:
Hi, I have Tow Ready part # 118413 wiring kit for my 2006 Highlander and also have an LED brake light with a one foot wires yellow brown and white. I want a flat four pin trailer end connector that comes with enough wire to reach inside vehicle so that the splice will be inside. Tow ready web site shows a part # 118033 that seems appropriate but I can only find a one foot long part on your site.
asked by: Rachel
Expert Reply:
We have a 20-foot 4-Way trailer side connector, # A20WB. This is a wishbone harness which means that the running light signal is split at the plug and the signal is sent along to each tail light rather than using a jumper wire between the two tail lights for the signal.
We also have a 35-foot harness, # A35W42B, that works the same way. I have included a link to a video showing this harness being installed for reference. Either harness will be compatible with the T-One Vehicle Wiring Harness with Converter and 4 Pole Trailer Connector, # 118413, on your 2006 Toyota Highlander.
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Trailer Connector With 4-Way Male Connector On Both Ends
- Q&A: Installing Leaf Springs on Single Axle Trailer
- Q&A: Screws Needed To Attach 5/8" Treated Plywood To Aluminum Snowmobile Trailer Frame
- Q&A: Where Are Loadstar Tires Made And What Will Cause Outer Tire Wear On One Tire On A Boat Trailer
- Q&A: How Far Apart Should the Leaf Spring Hangers Be Spaced With a 26 Inch Long Leaf Spring
- Q&A: How to Route 4-Way Connector Underneath 2011 Toyota Highlander
- Q&A: Will Hopkins Plug-In Simple Wiring Harness # HM11141845 Fit 2016 Toyota Highlander