Electric Stabilizer Jack Recommendation for 2016 Thor Vegas Motorhome
Published 04/07/2017
Question:
I have a 2016 Thor Vegas MH on a E-450 Cutaway chasis. Was interested in rear ultrafab electric stabilizer. width of rear frame outside too outside is 42/3/4 foot . Bottom of frame to ground is 17 1/2 inches.
asked by: C. E
0
Expert Reply:
Since your frame dimension is 42-3/4 inches from outside to outside the correct Ultra Fab electric stabilizer kit you need is the part # UF39-941707. This fits trailer frames between 42 and 77 inches apart plus has a lift of up to 22 inches so your frame being 17-1/2 inches from ground would be fine.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Ultra-Fab Power Twin II Electric Stabilizer for Trailers and RVs - 22" Lift - 6,000 lbs
- Camper Jacks
- 5th Wheel Camper
- Travel Trailer
- Stabilizer Jacks
- Steel
- 5001 - 6000 lbs
- Electric Jack
- 22 Inch Lift
- Bolt-On
- 1 Jack
- Ultra-Fab Products
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: How to Determine Fit of Ultra-Fab Power Twin II Electric Stabilizer
- Q&A: Scissor jacks vs Ultra-Fab Power Twin II Electric Stabilizer
- Q&A: Can The Ultra-Fab Electric Stabilizer Be Added To A Trailer With A Lippert Stabilizer
- Q&A: Does Lippert High-Speed Power Stabilizer Jack Have a Weight Capacity
- Q&A: Replacement Landing Gear Motor, Gear Box and Switch for Model 1A065012-02-01
- Q&A: Does Replacement Lippert Motor LC183058 Come with Instructions
- Q&A: Can I Install a 4-Point Control Module to a 6-Point Lippert Ground Control and Only Use Four Jacks?
- Article: Still Rocking After Leveling? How to Stabilize Your RV for Good
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: How to Install E-Track in 3 Easy Steps
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Raise Your Travel Trailer Height
- Article: Trailer Lighting Requirements