Troubleshooting Swivel Jack That Will Not Swivel
Updated 03/13/2017 | Published 03/11/2017
Question:
Hello. It seems that my jack doesnt want to swivel. Very stiff. I must force it to swivel. Is there an adjustment? Thank you
asked by: Bill
0
Expert Reply:
There really is no adjustment for this model swivel jack.
You could try to spray the pivot point between the jack and mount with a good penetrating oil. There may be some dirt or rust in the swivel point that this spray lube can penetrate and free up the jack and allow it to swivel up and down.
expert reply by:
Jared P
0
Product Page this Question was Asked From
Fulton Boat Trailer Jack Stand w/ Wheel - Swivel - Silver - 400 lbs
- Trailer Jack
- Boat Trailer
- Utility Trailer
- Side-Mount Jacks
- Swivel Jacks
- Marine Grade
- 0 - 1000 lbs
- Manual Jack
- 15 Inch Lift
- Bolt-On
- With Wheel
- Fulton
more information >
Continue Researching
- Article: How to Launch a Boat from a Trailer (And Load it Back Up)
- Q&A: Replacement Trailer Grease Seal for an NOK AD2527E Seal on a Boat Mate Trailer
- Q&A: Mounting Bracket Options for Optronics Sealed, Thin Line Clearance Side Marker Light # MC65AB
- Q&A: Can I Swap Out 4.80x12 Tires for 20.5x8x10 Tires for More Stability?
- Q&A: Dimensions of Bolt that Comes with the BoatBuckle Boat Winch Strap IMF05848
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Replacement for Atwood 61101 Brake Actuator
- Q&A: Is there a Trailer Wheel that Fits a 4 on 3 Inch Bolt Pattern
- Q&A: What Are The Dimensions On The Fulton Snap-Ring Swivel Marine Jack with Fixed Length # F1410050149
- Article: Diode Installation Instructions for a Dinghy with Separate Tail Light Wiring
- Article: How to Measure for Trailer Hitch Drop
- Article: Tow Bar Wiring: Which Wiring Kit is for You?
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Lighting Requirements