Brake Controllers Will Not Activate Electric Reverse Lockout Solenoid on Boat Trailers
Updated 03/13/2017 | Published 03/11/2017 >
Question:
I have a 2006 Toyota 4runner SR5 and a boat trailer with hydraulic surge brakes and has a solenoid that will lock up the brakes on the trailer when backing up. Installed a Drawtite I command brake controller with the 3040-P Tekonsha brake control wiring harness. The controller is not working either. Seems like it is missing a wire that tells the solenoid to release the brakes when in reverse. Help. What are my options?
asked by: Ron
Expert Reply:
A hydraulic coupler that has an electric reverse lockout does not get the signal to release the brakes from a brake controller when backing up. Brake controllers are for electric brakes and some work with electric over hydraulic systems. The Prodigy P2 # 90885 only works with electric brakes.
What does activate that lockout solenoid is the reverse light circuit on a vehicle. That solenoid has to be wired to the reverse light circuit on a trailer connector (usually a 5-Way or a 7-Way) so when the vehicle is put in reverse it energizes the solenoid and does not allow fluid to go back to the brakes. If you have a 5- or 7-Way connector on both the trailer and vehicle and the brakes still lock up when you back up then either the reverse light circuit does not function on the tow vehicle or the solenoid is bad.