Troubleshooting Brake Controller 5535 with o.9 Flashing
Published 01/26/2017
Question:
Hooked up the 5535 to my 2000 GMC 2500 and PJ dump trailer. I can input gain and boost selections, but all I get after that is a flashing what looks like the top of digital 8 then a . and a 9 and a dot o.9.
asked by: JT
0
Expert Reply:
The o.9 that you are seeing indicates that the controller has a weak ground but is sensing a trailer connection. Ensure the white wire of the controller is connected to a solid ground and you will see the controller start working properly.
expert reply by:
Jameson C
0
Continue Researching
- Q&A: What Does the Little Zero and a 9 Error Mean on a Hayman Reese Guardian IQ Brake Controller?
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Brake Controller Recommendation for a Truck with Air Brakes and a Trailer with Electric Brakes
- Q&A: Will The Replacement Cooking Rack # 324-000151 Fit a HighPointe Convection Microwave?
- Q&A: Recommended Replacement Cylinder Kit for a Dexter Hydraulic Drum Brake Kit
- Q&A: Replacement Trailer Clearance Lights PM-108-15 SAE-AP2-79
- Q&A: Recommended Replacement For A Marshall 605H LP Regulator
- Q&A: Are Spacers in 5th Wheel Installation Kit RP50082-58 Required for Installation
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Troubleshooting Brake Controller Installations
- Article: Trailer Wiring Diagrams
- Article: Brake Controller Installation: Starting from Scratch
- Article: Brake Controller Installation on a Ford Full-Size Van
- Article: Brake Controller Installation on a Full-Size Ford Truck or SUV