Recommended Ball Mount With 5-1/2 Inch Rise For 2-Inch Hitch

Question

Question:

Hi, I need a 2 inch ball mount with about a 5.5 inch rise but I am having a problem finding one. Do you have one? thanks,

asked by: Allan

0

Expert Reply:

We do not have any fixed ball mounts with a 5-1/2 inch rise specifically but we do have them with a 5-inch or 6-inch rise like part # 40332 and part # C24WR.

You may want to consider an adjustable mount that gives you some flexibility. The ball mount I recommend is the Convert-a-Ball Adjustable-Height Ball Mount, part # TK5007. This is adjustable up to a 10-inch drop or an 9-inch rise.

If you need a 2-inch hitch ball I recommend part # 63845. For a 1-7/8 inch ball I recommend part # C40051.

expert reply by: Jesse M

0

Answer 1

I have a possible solution, but none of the 14-16" extensions have a high enough capacity. The only thing that comes close is the Gen-Y #GY89SR which has a gross towing weight of 10,000 lbs, but the max tongue weight is only 500 lbs. This would…

view full answer...

Answer 2

I went out to the warehouse and measured the A-Frame Trailer Coupler #CA-5280-RB and found that from the widest point to the smallest point it measured 10-9/16" and 2-5/8" respectively. This will give you the angle. The overall height of…

view full answer...

Answer 3

The first thing you will need to add a brake controller to your 2020 Toyota Tacoma is 7-way wiring. If you don't already have it, you can use the Tekonsha OEM Replacement Vehicle Wiring Harness w Brake Controller Adapter #22117. After that all…

view full answer...

Answer 4

The etrailer A-Frame Trailer Coupler w/ Round Jack Hole #CA-5280-RB uses the standard a-frame angle of 50 degrees. The length from the rear of the coupler to where the coupler meets its narrowest point is approximately 9" long. I have include…

view full answer...

Answer 5

The only way will be to replace the entire assembly as the rear back plate is not available by itself. For that you'd need the part #RVSTLB61. The great news is that the price for this is very reasonable and you get an all new assembly.

view full answer...

Answer 6

On your 2015 Mazda CX-5, the measurement you need is from the ground to the inside top of the receiver. If you look at the attached video we that measurement listed at 15-1/2 inches so it is different from the 13 inch you referenced. For your 13 inch…

view full answer...

Answer 7

With Draw-Tite trailer hitch #75782 installed on your 2016 Ford Escape the distance from the ground to the top of the receiver opening will be approximately 14 inches. If you plan on doing some light towing you will want to grab our etrailer Ball…

view full answer...

Recommended Ball Mount With 5-1/2 Inch Rise For 2-Inch Hitch

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching