Is There A Wiring Adapter To Install Draw-Tite Activator IV Brake Controller On 2003 Hummer H2

Published 10/06/2010

Products Featured in This Question

Draw-Tite Activator IV Trailer Brake Controller - Up to 4 Axles - Time Delayed

(357)

$103.31

Replacement Custom Multi-Tow 7-Way and 4-Way Trailer Connectors

(411)

$44.25

Question:

I already have a drawtite activator 4 brake control box from my old vehicle. Do you sell the adaptor for installaton in my 2003 hummer h2? Can you tell me where to find where to plug in the adaptor?

asked by: jeff

Expert Reply:

Yes, the adapter you will need to install the Draw-Tite Activator IV Brake Controller on your 2003 Hummer H2 is the Universal Brake Control Wiring Adapter, part # 3015-S. You will need to match the corresponding colored wires to the color wires coming out of the brake controller. You will want to twist the exposed wire and connect each wire individually with the included butt connectors. Then, wrap each connection in electrical tape. The other end of the adapter will plug into the port located under the dash of your Hummer near the emergency brake.

If you do not have a factory 7-way on your Hummer you will need to install Replacement Multi-Tow 7-Way and 4-Way, part # 30955. To install part # 30955, use the included mounting bracket to mount at the rear of your Hummer, and the harness will plug into the existing vehicle harness located above the spare tire.

expert reply by: Reno H