Drawbar Neck Length on a Self-Locking Adjustable Aluminum Ball Mount, Part # DTALBM7000
Published 09/22/2010
Question:
Do you have the length of how long the shank is? I just need to make sure I have enough clearance from the ground, but this seems to be the size I need.
asked by: Nick P
Expert Reply:
I called my contact at Diversi- Tech to get the measurements for the Self-Locking Adjustable Aluminum Ball Mount, 2 Balls, Up to 11 inch Rise or 10 inch part # DTALBM7000, you referenced and was able to come up with the following measurements.
The total length of neck on the shank is 13 inches.
The length of the portion of the neck that actually hangs lower than the center of the hitch pin is 11-5/8 inches.
If you were to have the ball in the lowest position to where the lower ball not being used was hanging down beyond the length of the neck it would measure 14-3/8 inches below the center of the hitch pin on the stinger.
