License Plate Mounting Anchors for BigTex 70TV Trailer
Updated 01/06/2016 | Published 01/05/2016
Question:
Im new at this. My BigTex 70TV trailer has two 3/8inch square holes in only the outer surface of the square tube frame. What fasteners/fastening system should I use? If its CR81200, can I be sure the plastic plugs never pop out?
asked by: Terry K
0
Expert Reply:
The 3/8 inch square holes on your trailer are what the Star Pin Locking Fasteners # CR81200 are designed to fit. You would need to pop the anchors into the vehicle and then use the unique mounting screws to tighten and secure the license plate.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Star Pin Locking Fasteners for License Plates and Frames - Stainless Steel - Standard - Qty 4
- Accessories and Parts
- License Plates and Frames
- Fasteners
- Locking
- Standard
- Cruiser
more information >
Continue Researching
- Q&A: Husky Electric Tongue Jack Will Lower But Not Raise
- Q&A: Will Tuf Combo License Plate Frame and Clear Shield Work on 2017 Ram 2500 and Needed Hardware
- Q&A: Looking for a Spare Tire Cover for the Provider ST235/80R16 Trailer Tire with Black Mod Wheel
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Stability Control for Heavy Duty Vehicles
- Article: Ram Trailer Tow Prep Package
- Q&A: Dimensions for Buyers Product Wiring Junction Box # 3375601101
- Q&A: Can a Junction Box be Used for 4-Way Flat Trailer Connector
- Q&A: Light Kit and License Bracket Holder Recommendation for the Hollywood Racks Sport Rider SE
- Q&A: Can LED License Plate Light be Wired to Trailer 7-Way and Plugged into a Vehicle 7-Way