Is Bumper/FasciaTrimming Required to Install Trailer Hitch # 75673 on a 2010 Subaru Outback Wagon

Updated 06/17/2010 | Published 06/16/2010

Products Featured in This Question

Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"

(1019)

$209.61

T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector

(2968)

$49.38

etrailer Ball Mount Kit for 2" Hitches - 7,500 lbs

(1375)

$85.76

Question:

Does this hitch fit below the bumper like many after market hitches or does it come out of a hole you cut in the lower bumper like the Subaru dealer installed hitch does?

asked by: James P

Expert Reply:

To install the Draw-Tite Trailer Hitch, # 75673, you will not have to trim or cut out a hole in the rear bumper or fascia on your 2010 Subaru Outback Wagon. There is some minor heat shield trimming required, however. I have included a link to the installation instructions below that shows where the trimming will occur.

If you plan to tow with this hitch, I recommend adding etrailer Ball Mount Kit # 989900 and Tow Ready Custom Fit Vehicle Wiring, part # 118467. This wiring plugs in line with a connector already on the vehicle, and provides a 4-Way trailer connector at the rear of the vehicle. I have included a links to the installation details and a video installation of this wiring below, as well as to some general information on towing.

expert reply by: Michael H